#How to change vfo mode on tyt uv8000e software
#How to change vfo mode on tyt uv8000e code

Push the key on the lower right edge of the keypad. Now letвЂ™s get started! Turn on the radio and make sure your radio is in VFO mode. If youвЂ™re starting from scratch or have some memories open, jot down one of the open memory channels here for later use - _Д«efore we get started, a reminder that you need to be a licensed amateur radio operator to use any amateur radio repeaters. If your radio has already been completely programmed by us and you have no empty memory spaces available, you must select one memory location to later override.

#How to change vfo mode on tyt uv8000e software

In the case of the TYT TH-UV8200 radio, you have 256 memories available within the radio, so most folks either purchase a pre-programmed radio or the computer software and cable kit from us directly (to save enormous amounts of time getting their radio(s) ready).

Once you have acquired the information needed above, youвЂ™re ready to start the programming sequence for one memory. For the sake of having everything handy, write down your negative or positive offset here - _ A positive offset would show on the display as вЂњ+вЂќinstead. If the repeater output frequency is 447.000 MHz (for example) and the input frequency is 442.000 MHz, then your repeater has a 5.000 MHz вЂњsplitвЂќwith a negative offset (normally shown on the radio display as вЂњ-вЂќ). the repeaterвЂ™s input frequency (the frequency you need to transmit to the repeater). To determine if your repeater has a positive or negative shift, look at the repeaterвЂ™s output frequency (what you listen to) vs. If your repeater doesnвЂ™t use the standard вЂњsplitвЂќ, write down your repeaterвЂ™s вЂњsplitвЂќ here - _ Be advised that some repeater owners and clubs donвЂ™t always use the standard вЂњsplitвЂќ for a variety of reasons, so itвЂ™s best to check and make sure before getting started. In most areas of the country, the вЂњsplitвЂќ for UHF repeaters is 5.000 MHz and for VHF repeaters the вЂњsplitвЂќ is normally 600 KHz (shown on most displays as 0.600 MHz). Since you are manually programming this memory, you will also need the repeater вЂњsplitвЂќ (or input frequency) and the repeaterвЂ™s shift (either positive or negative).

In MESA 01 through MESA 20 and know precisely which repeater is which (by only looking at those 7 letters) - unless you keep a printout of your programming handy. List your choice (callsign/frequency/location) here: _ There are no right or wrong choices in naming yourД¬hannel memories, but if you are lucky enough to have many different repeaters in your area (in my case Gilbert/Mesa, AZ), itвЂ™s hard to program Radios do, but as youвЂ™ll see later, itвЂ™s not a simple or quick process to complete manually.

Radios allow you to manually name the callsign or list the repeater location directly from the keypad (or allow lower-case letters). Repeater location (be advised that the TYT TH-UV8200 allows 7 alpha or numeric characters, in both UPPER and lower-case letters).

#How to change vfo mode on tyt uv8000e code

Get the repeater PL (CTCSS) or DCS code if thatвЂ™s required for repeater access -_Дecide in advance if you will list the repeater selection within your radio by the repeater callsign, the repeater output frequency, or the Get the repeater output frequency - _ MHz